Learning About the Log and Capture Window
The Log and Capture window provides controls for controlling a VTR or camcorder,
previewing video from tape, setting In and Out points, logging, and capturing clips.
To open the Log and Capture window:
m
Choose File > Log and Capture (or press Command-8).
There are several areas in the Log and Capture window.
 Preview area: On the left is the area where you view video while logging clips. This
area contains transport controls, marking controls, and timecode fields. If device
control is not enabled, the transport controls do not appear.
 Tabs: On the right are the Logging, Clip Settings, and Capture Settings tabs.
 Log and capture buttons: You use one of these buttons when you are ready to log a
clip or capture media.
Log and capture
buttons
Preview area
Logging, Clip Settings, and
Capture Settings tabs
240
Part IV
Logging, Capturing, and Importing