Determining What Parts of Clips You Want in Your Sequence
To specify what part of a clip you want in your sequence, you open it in the Viewer and
set In and Out points. The In point is the first frame of the clip you want to use in a
sequence, and the Out point is the last frame. For information about setting In and Out
points for clips, see Chapter 7, “
Setting Edit Points for Clips and Sequences
,” on page 99.
If you like, you can also add an entire clip to your sequence, without setting In or Out
points for it. For information, see “
Dragging Clips to the Timeline
” on page 138.
Instead of adding clips to your sequence one at a time, you can organize a group of
clips in the Browser and drag all of them to your sequence at the same time. For
information about adding groups of clips directly to your sequence, see the next
section, “
Preparing a Sequence Order in the Browser
.”